METALLURGY


Tube inspection system
France ©Metalscan
Read more.
Pitting detection with TFM and MANTIS
Here is a comparison of a linear scanning using 8 elements focused close to the backwall and a TFM using
Read more.
Casting Test
Shrink Hole Indication
Read more.
High productivity bar inspection
KOREA ©METALSCAN
Read more.
Automated inspection in an immersion tank
This system has been installed by SCANMASTER in Russia.
Read more.
Weld pipe inspection
GERMANY ©Scanmaster
Read more.
Welded and seamless tube inspection system
Welded and seamless tube inspection in France. ©Metalscan.
Read more.
Stainless steel pipes 100% inspected
Read more.
Tube inspection
This system has been installed to inspect 100% of stainless steel pipes. GERMANY ©KARL DEUTSCH
Read more.
Austenitic welds
Ultrasonic inspection of austenitic welds is qualified for in-service inspection since beginning of 2000’s. Implementation of the solution based on
Read more.
Weld inspection
This article shows a video of a multi-group weld inspection, using 2 phased-array and a pair of TOFD probes. With
Read more.
Screw thread inspection
27-mm long screw thread inspection with TFM technique. Optimal resolution is obtained along the thread. Probe: PA, 5 MHz, 64
Read more.
Multi-group weld inspection using MANTIS
This article shows a video of a multi-group weld inspection, using 2 phased-array and a pair of TOFD probes. With
Read more.
Y-joint inspection
By Frédéric REVERDY, Business Development Manager in M2M A while back we had a post about a T-joint inspection with
Read more.
Incomplete root penetration (bridging) on a T section
By Frédéric REVERDY, Business Development Manager in M2M Detection of an incomplete root penetration (bridging) on a T section. The
Read more.
Surface breaking crack characterization with TFM
By Frédéric REVERDY, Business Development Manager in M2M A while back I had a post about surface breaking crack characterization
Read more.
Nozzle inspection on GEKKO
By Frédéric REVERDY, Business Development Manager in M2M Ultrasonic Inspection of nozzles has always been a challenge due to the
Read more.
Welds
Welds are often critical parts to inspect. They are subject to huge constrains and have to be inspected with NDT
Read more.
Corrosion
Corrosion can induce wall thickness and pitting. Challenge is to map fast with high accuracy and high probability of detection.The
Read more.
Corrosion mapping improvement
(Portuguese version only) Avanço da monitoração da corrosão pela técnica ultrassônica phased array FMC/TFM   SINOPSE A contínua monitoração do
Read more.