POWER GENERATION


Pitting detection with TFM and MANTIS
Here is a comparison of a linear scanning using 8 elements focused close to the backwall and a TFM using
Read more.
Offshore Wind Power T-joint construction weld
Application of TFM for defect sizing in welded joints. These below pictures show T-joints at the offshore windmill construction. The material
Read more.
Heat exchanger tube inspection
M2M has been working with Metalscan for the integration of these MultiX++ instrumentation in India.
Read more.
Automated girth weld inspection of a wind turbine
PORTUGAL ©ISQ
Read more.
Small diameter pipe inspection
In this case, a cylindrical reconstruction is being done for small diameter pipe inspection using sizing with corner effect mode
Read more.
Weld inspection
This article shows a video of a multi-group weld inspection, using 2 phased-array and a pair of TOFD probes. With
Read more.
Characterization of misoriented notch
Tilted defect reconstruction with TFM technique and mode conversion with a probe of 5 Mhz, 64 elements, and a S
Read more.
Elliptical notches
True imaging of 2-mm elliptical fatigue crack- Sizing of defects possible even without a diffraction signal- True-shape imaging of defects
Read more.
Skewed defects detection
Use of matrix probe with sectorial scanning along various planes perfect for the detection of skewed defects.      
Read more.
Boiler tube inspection
BOILER TUBE INSPECTION GEKKO can use scanners for boiler tube inspection and use two 32-element PA for the inspection from both
Read more.
Blade root inspection with half-skip TFM
TFM and superimposition of a CAD file to ease the inspection diagnostic. The inspection has been carried using a 5
Read more.
Blade rotor groove inspection
With GEKKO equipment, it is possible to import 2D CAD files as overlays to help interpret echoes.
Read more.
Turbine inspection
This example of a tree root blade shows that geometry echoes are present and the CAD overlay makes interpretation easier.
Read more.
Screw thread inspection
27-mm long screw thread inspection with TFM technique. Optimal resolution is obtained along the thread. Probe: PA, 5 MHz, 64
Read more.
Inspection of Electro Fusion Fittings using GEKKO
Watch the full video here This video shows an inspection of Electro Fusion Fittings using flaw detector GEKKO, a 5
Read more.
Polyethylene weld inspection using TFM
Guillaume Neau, head of M2M North America, explaining the TFM imaging of a polyethylene weld inspection, using a 2MHz probe and
Read more.
Nozzle-to-pipe inspection from the nozzle side
By Frédéric REVERDY, Business Development Manager in M2M A while back we posted an article showing the application developed for
Read more.
Inspection of a small nozzle with GEKKO
By Frédéric REVERDY, Business Development Manager in M2M We looked at a small nozzle (1" diameter) with a 5L16 small
Read more.
Incomplete root penetration (bridging) on a T section
By Frédéric REVERDY, Business Development Manager in M2M Detection of an incomplete root penetration (bridging) on a T section. The
Read more.
Surface breaking crack characterization with TFM
By Frédéric REVERDY, Business Development Manager in M2M A while back I had a post about surface breaking crack characterization
Read more.