Below are application cases using the streamlined CAPTURE interface (available in MANTIS and GEKKO).
Need for Speed…TFM Speed
By Frederic Reverdy, M2M Product Sales Specialist at Eddyfi Technologies Back in 2014, M2M now Eddyfi, was the first one on theRead more.
Analysis on M2M Gekko Capture 2.3
By Frederic Reverdy, M2M Product Sales Specialist at Eddyfi Technologies The following image is an inspection done with two phased-array probes. In theRead more.
Delay law calculator extended in M2M Capture V2.3
By Frederic Reverdy, M2M Product Sales Specialist at Eddyfi Technologies Another peak view at the 2.3 version of M2M Capture coming upRead more.
Curved wedge calibration in M2M Capture V2.3 software
By Frederic Reverdy, M2M Product Sales Specialist at Eddyfi Technologies A sneak preview of one of the many features that will beRead more.
Offshore Wind Power T-joint construction weld
Application of TFM for defect sizing in welded joints. These below pictures show T-joints at the offshore windmill construction. The materialRead more.
PAUT T-joint inspection
Crack detection in a T-joint using GEKKO. We are looking at a 5-mm under-bead crack in one of theRead more.
Using Total Focusing Method (TFM) for the inspection of inconel weld, a extended vizualisation area is obtained. Defects are detectedRead more.
This video shows an electronic scanning of a PMMA (polymethyl methacrylate also called acrylic glass) plate using the flaw detectorRead more.
Small diameter pipe inspection
In this case, a cylindrical reconstruction is being done for small diameter pipe inspection using sizing with corner effect modeRead more.
High temperature hydrogen attack (HTHA)
HTHA damage is detected using AUBT method (Advanced Ultrasonic Backscattering Technique) that evaluates the frequency and velocity dependence to aRead more.
Nozzle-to-pipe inspection from the nozzle side
By Frederic Reverdy, M2M Product Sales Specialist at Eddyfi Technologies A while back we posted an article showing the application developed forRead more.
Acquisition of the Full Matrix Capture (FMC) data for post-processing
By Frédéric REVERDY, Business Development Manager in M2M While both the Gekko and the Mantis were developed for the field,Read more.
CAPTURE (Gekko and Mantis software) 2.1 version release
By Frédéric REVERDY, Business Development Manager in M2M The new version of the Capture software (Gekko and Mantis software) was released.Read more.
Cracks in clads
It is possible to detect cracks in the cladding using TFM by focalizing the energy everywhere and using a largeRead more.
M2M has developed a unique nozzle inspection application that allows: - to define a nozzle geometry on board - to display inRead more.